Cisco 8800 Series Hardware Installation Guide

CHAPTER 3
Unpack and Install the Chassis
The images in this chapter are only for representation purposes, unless specified otherwise. The chassis' actual
appearance and size may vary.
Note
• Unpack the Chassis, on page 23
• Install Bottom-Support Rails, on page 27
• Transfer Chassis to a Mechanical Lifting Device, on page 28
• Mount Chassis Into the Rack, on page 30
• Install Cable Management on a Chassis , on page 45
• Attach Front Door to Chassis, on page 56
Unpack the Chassis
Be sure to save the packaging in case you need to return any of the components products.
Tip
Ensure that there is sufficient room around the chassis pallet for unpacking. For information about the chassis
dimensions and clearance requirements see, Clearance Requirements.
Carefully move the pallet containing the chassis to the staging area where you plan on unpacking it.
Hardware Installation Guide for Cisco 8800 Series Routers
23

Cisco 8800 Series Specifications

General

Protocols	SIP, SCCP
Audio	Wideband audio
Connectivity	Gigabit Ethernet
Power	Power over Ethernet (PoE)
Bluetooth	Yes
USB	Yes
Codec Support	G.711, G.722, G.729, iLBC
Dimensions	Varies by model
Weight	Varies by model
Wi-Fi	Yes (varies by model)