When you enter the same password, the software accepts the password.
Step 5 Enter the configuration mode.
Step 6 Enter the IP address for the management interface. If using dual RPs, enter the IP address on both management
interfaces.
Step 7 Enter a network mask for the management interface.
Step 8 The software asks whether you want to edit the configuration. Enter 'no' to decline.
Verify Chassis Installation
After installing the chassis, use the following show commands to verify the installation and configuration in
the EXEC mode. Any issue if detected, take corrective action before making further configurations.
DescriptionCommand
Displays the state information of each card.show platform
Displays the status of route processor redundancy.show redundancy
Displays LED information for the router, or for a specific LED location.show led
Displays field-programmable device (FPD) compatibility for all modules or a specific module.show hw-module fpd
Displays all existing alarms in the router.show alarms brief system
active
Displays the current state of the disk storage media.show media
Displays information about the field replaceable units (FRUs), including product IDs, serial numbers,
and version IDs.
show inventory
Displays all the environment-related router information.show environment
Hardware Installation Guide for Cisco 8800 Series Routers
88
Connect Router to the Network
Verify Chassis Installation
To Next Page
Loading...
Need help?
General
