Cisco 8861 - Page 392

DescriptionParameter
If set to Yes, as a transferee, the phone will send a
NOTIFY with Event:Refer to the transferor for any
1xx response returned by the transfer target, on the
transfer call leg.
If set to No, the phone will only send a NOTIFY for
final responses (200 and higher).
Perform one of the following:
• In the phone configuration file with
XML(cfg.xml), enter a string in this format:
<Ntfy_Refer_On_1xx-To-Inv_1_
ua="na">Yes</Ntfy_Refer_On_1xx-To-Inv_1_>
• In the phone web page, select Yes to enable this
feature.
Allowed values: Yes|No
Default: Yes
Ntfy Refer On 1xx-To-Inv
Configure G.729 Annex B settings.
Perform one of the following:
• In the phone configuration file with
XML(cfg.xml), enter a string in this format:
<Set_G729_annexb_1_
ua="na">Yes</Set_G729_annexb_1_>
• In the phone web page, select Yes to enable this
feature.
Allowed values: None|No|Yes|Follow silence supp
setting
Default: Yes
Set G729 annexb
Cisco IP Phone 8800 Series Multiplatform Phone Administration Guide for Release 11.3(1) and Later
372
Cisco IP Phone Installation
Parameters for SIP Settings on Extensions