DescriptionField
FPD type. Can be one of the following types:
• fabldr—Fabric downloader
• fpga1—Field-programmable gate array
• fpga2—Field-programmable gate array 2
• fpga3—Field-programmable gate array 3
• fpga4—Field-programmable gate array 4
• fpga5—Field-programmable gate array 5
• rommonA—Read-only memory monitor A
• rommon—Read-only memory monitor B
Subtype
FPD instance. The FPD instance uniquely identifies
an FPD and is used by the FPD process to register an
FPD.
Inst
Currently running FPD image version.Current SW Version
Specifies whether an FPD upgrade or downgrade is
required. A downgrade is required in rare cases when
the version of the FPD image has a higher major
revision than the version of the FPD image in the
current Cisco IOS XR software package.
Upg/Dng?
show fpd package Command Output: Example
Use the show fpd package command in administration EXEC mode to find out which SPAs and SIPs are
supported with your current Cisco IOS XR software release, which FPD image package you need for each
SPA or SIP, and what the minimum hardware requirements are for each module. If multiple FPD images are
available for your card, they are listed as Subtype fpga2, fpga3, and so on.
The following example shows sample output from the show fpd package command:
RP/0/RP1/CPU0:router(admin)# show fpd package
Thu Jul 7 04:34:48.351 DST
=============================== ================================================
Field Programmable Device Package
================================================
SW Min Req Min Req
Card Type FPD Description Type Subtype Version SW Ver HW Vers
==================== ========================== ==== ======= =========== ======== =========
A9K-40GE-B Can Bus Ctrl (CBC) LC2 lc cbc 2.02 0.0 0.1
CPUCtrl LC2 lc cpld1 1.00 0.0 0.1
PHYCtrl LC2 lc cpld2 0.06 0.0 0.1
Cisco ASR 9000 Series Aggregation Services Router System Management Configuration Guide, Release 5.1.x
165
Upgrading FPD
show fpd package Command Output: Example
To Next Page
Loading...
Need help?
General
