PurposeCommand or Action
(Optional)
Adjusts the estimated round-trip delay for NTP broadcasts.
broadcastdelay microseconds
Example:
RP/0/RSP0/CPU0:router(config-ntp)#
broadcastdelay 5000
Step 3
Enters NTP interface configuration mode.
interface type interface-path-id
Example:
RP/0/RSP0/CPU0:router(config-ntp)#
interface POS 0/1/0/0
Step 4
Configures the specified interface to receive NTP broadcast packets.broadcast client
Step 5
Example:
RP/0/RSP0/CPU0:router(config-ntp-int)#
broadcast client
Go to Step 6, on page 213 to configure the interface to send
NTP broadcast packets.
Note
Configures the specified interface to send NTP broadcast packets.
broadcast [destination ip-address] [key key-id]
[version number]
Step 6
Go to Step 5, on page 213 to configure the interface to
receive NTP broadcast packets.
Note
Example:
RP/0/RSP0/CPU0:router(config-ntp-int)#
broadcast
destination 10.50.32.149
Saves configuration changes.Use one of the following commands:
Step 7
•
end
•
When you issue the end command, the system prompts you
to commit changes:
Uncommitted changes found, commit them before
•
commit
Example:
RP/0/RSP0/CPU0:router(config-ntp-int)#
end
exiting(yes/no/cancel)?
[cancel]:
â—¦
Entering yes saves configuration changes to the running
configuration file, exits the configuration session, and
returns the router to EXEC mode.
or
RP/0/RSP0/CPU0:router(config-ntp-int)#
commit
â—¦
Entering no exits the configuration session and returns
the router to EXEC mode without committing the
configuration changes.
â—¦
Entering cancel leaves the router in the current
configuration session without exiting or committing the
configuration changes.
•
Use the commit command to save the configuration changes
to the running configuration file and remain within the
configuration session.
Cisco ASR 9000 Series Aggregation Services Router System Management Configuration Guide, Release 5.1.x
213
Implementing NTP
Configuring Broadcast-Based NTP Associates
To Next Page
Loading...
Need help?
General
