Cisco A9K-SIP-700 User Manual

SUMMARY STEPS
1.
configure
2.
ntp
3.
Use one of the following commands:
•
no interface type interface-path-id
•
interface type interface-path-id disable
4.
Use one of the following commands:
•
end
•
commit
DETAILED STEPS
PurposeCommand or Action
configure
Step 1
Enters NTP configuration mode.ntp
Example:
RP/0/RSP0/CPU0:router(config)# ntp
Step 2
Disables NTP services on the specified interface.Use one of the following commands:
Step 3
•
no interface type interface-path-id
•
interface type interface-path-id disable
Example:
RP/0/RSP0/CPU0:router(config-ntp)# no
interface pos 0/0/0/1
or
RP/0/RSP0/CPU0:router(config-ntp)#
interface POS 0/0/0/1 disable
Saves configuration changes.Use one of the following commands:
Step 4
•
end
•
When you issue the end command, the system prompts you
to commit changes:
Uncommitted changes found, commit them before
•
commit
Example:
RP/0/RSP0/CPU0:router(config-ntp)# end
exiting(yes/no/cancel)?
[cancel]:
Cisco ASR 9000 Series Aggregation Services Router System Management Configuration Guide, Release 5.1.x
218
Implementing NTP
Disabling NTP Services on a Specific Interface

Cisco A9K-SIP-700 Specifications

General

Brand	Cisco
Model	A9K-SIP-700
Category	Network Router
Language	English