Cisco A9K-SIP-700 User Manual

DETAILED STEPS
PurposeCommand or Action
configure
Step 1
Enters PTP configuration mode.ptp
Step 2
Example:
RP/0/RSP0/CPU0:router(config)# ptp
Enters PTP profile configuration mode for the specified profile.
profile name
Step 3
Example:
RP/0/RSP0/CPU0:router(config-ptp)# profile
tp64
Configures the Sync message frequency for the profile.
sync frequency rate
Example:
RP/0/RSP0/CPU0:router(config-ptp-profile)#
sync frequency 64
Step 4
Sets the delay request frequency for the profile.
delay-request frequency rate
Example:
RP/0/RSP0/CPU0:router(config-ptp-profile)#
Step 5
delay-request
frequency 64
Saves configuration changes.Use one of these commands:
Step 6
•
end
•
When you issue the end command, the system prompts you
to commit changes:
Uncommitted changes found, commit them
before exiting(yes/no/cancel)? [cancel]:
•
commit
Example:
RP/0/RSP0/CPU0:router(config-ptp-profile)#
end
◦
Entering yes saves configuration changes to the running
configuration file, exits the configuration session, and
returns the router to EXEC mode.
or
RP/0/RSP0/CPU0:router(config-ptp-profile)#
commit
◦
Entering no exits the configuration session and returns
the router to EXEC mode without committing the
configuration changes.
◦
Entering cancel leaves the router in the current
configuration session without exiting or committing the
configuration changes.
•
Use the commit command to save the configuration changes
to the running configuration file, and remain within the
configuration session.
Cisco ASR 9000 Series Aggregation Services Router System Management Configuration Guide, Release 5.1.x
240
Configuring PTP
Configuring Global Profile Settings for PTP

Cisco A9K-SIP-700 Specifications

General

Brand	Cisco
Model	A9K-SIP-700
Category	Network Router
Language	English