Name: Cisco ASR 1013
Brand: Cisco
Rating: 5 (1 reviews)

To Next Page

To Previous Page

• Booting and rebooting the router

• Understanding software packages for the Cisco ASR 1000 Series Aggregation Services Routers

• Software Upgrades

7 After Installation

Follow the instructions in this section to replace field replaceable units (FRUs) after installation. The Cisco ASR 1013 Router

supports the following components as FRUs:

• Cisco ASR1000-ESP40 embedded services processors

• Shared port adapters

• Power supplies

Note For a complete list of Cisco ASR 1000 Series Routers field replaceable units, go to Cisco ASR 1000 Series Aggregation

Services Routers Hardware Installation Guide.

The following topics are covered in this section:

• Powering Off the Cisco ASR 1013 Router Safely, page 28

• Replace a Power Supply in a Cisco ASR 1013 Router, page 29

• Install and Remove the Shared Port Adapter, page 33

Warning

Only trained and qualified personnel should be allowed to install, replace, or service this equipment.



Statement 1030

Powering Off the Cisco ASR 1013 Router Safely

This section explains how to shut down the Cisco ASR 1013 Router. It is recommended that before turning off all power to the

chassis, you issue the reload command. This insures that the operating system cleans up all the file systems. Once the reload

operation is complete, then the Cisco ASR 1013 Router can be powered off safely.

To remove power from a Cisco ASR 1013 Router safely, follow this procedure and see the examples:

Step 1 Slip on the ESD-preventative wrist strap that was included in the accessory kit.

Step 2 Enter the reload command.

Step 3 Confirm the reload command:

Rmcp-13ru-1#reload

Proceed with reload? [confirm]

Aug 17 00:06:47.051 R0/0: %PMAN-5-EXITACTION: Process manager is exiting: prs exit with reload chassis

code

Step 4 After confirming the reload command, wait until the system bootstrap message displays before powering off the system.

System Bootstrap, Version 12.2(33r)XN2, RELEASE SOFTWARE (fc1)

Technical Support: tap://www.cisco.com/techsupport

Current image running: Boot ROM0

Last reset cause: LocalSoft

ASR1000-RP2 platform with 4194303 Kbytes of main memory

mcp-13ru-1-rp0-rommon 1>

Cisco ASR 1013 Quick Start Guide

Other manuals for Cisco ASR 1013