Cisco ASR 1013 Quick Start Guide

20
Verifying Power Supply Operation
Follow this procedure to verify power supply is operating correctly in your Cisco ASR 1013 router.
Step 1 Check that the power supply LEDs are:
• INP
UT OK is green
• F
AN OK is green
• OUTPUT F
AILED is not illuminated
Step 2 T
o ensure that the power supply state is OK, type the show platform command. This output is only a sample from one
of the Cisco ASR 1000 routers.
MCP_SCAL_R1#sho plat
Chassis type: ASR1006
The following output displays:
Slot Type State Insert Time
1 ASR1000-SIP10 ok 00:03:19
1/1 SPA-8X1GE-V2 ok 00:02:23
2 ASR1000-SIP10 ok 00:03:19
2/0 SPA-1X10GE-L-V2 ok 00:02:22
2/1 SPA-8X1GE-V2 ok 00:02:17
R0 ASR1000-RP1 ok,active 00:03:19
F0 ASR1000-ESP20 ok,active 00:03:19
P0 ASR1006-PWR-AC ok 00:02:50
P1 ASR1006-PWR-AC ps, fail 00:02:50
Slot CPLD Version Firmware
Version
1 07091401 12.2(33r)XN2
2 07091401 12.2(33r)XN2
R0 08060301 12.2(0:0)
F0 08041102 12.2(33r)XN2
MCP_SCAL_R1#
If the LEDs indicate a power problem or the power supply state is ps, fail, then contact a customer service representatives for
assistance or additional instructions.
Start the System
After installing your Cisco ASR 1013 Router and connecting cables, start the router as follows.
Step 1 Check for the following:
• Mak
e certain that each shared port adapter is firmly seated in its subslot and its captive screws are securely tightened.
• The Cisco ASR1000-ESP40
embedded services processors in the Cisco ASR 1013 router are inserted in slot F0 and F1, is
firmly seated in its slot, and its captive screws are securely tightened.
• All n
etwork interface cables are connected.
• The con
sole terminal is turned on.
Step 2 T
urn on power. The green OK LED on the power supply turns on.

Cisco ASR 1013 Specifications

General

Brand	Cisco
Model	ASR 1013
Category	Network Router
Language	English