Cisco ASR 9001 Hardware Installation Guide

ValueDescription
Can be configured as one of the following:
•
BITS (Building Integrated Timing System) port
•
J.211 or UTI (Universal Timing Interface) port
Sync ports (0, 1)
Power Consumption Specifications
The following table lists the power consumption specifications for a fully configured chassis.
Be sure that the chassis configuration complies with the required power budgets. Failure to properly verify
the configuration may result in an unpredictable state if one of the power units fails. Contact your local
sales representative for assistance.
Caution
Table 29: Power Consumption Specifications
ValueDescription
400 W at 77°F (25°C)
425 W at 104°F (40°C)
450 W at 131°F (55°C)
Power consumption
The following modules are supported on fixed ports on the Cisco ASR 9001 and Cisco ASR 9001-S:
•
SFP-10G-ZR
•
SFP-H10GB-ACU7M
•
SFP-H10GB-ACU10M
•
DWDM SFP10G-3033 through DWDM SFP10G-6141
•
ONS-SC+-10G-C
The fixed ports on the Cisco ASR 9001 and ASR 9001-S do not support FastEthernet and GigabitEthernet
transceivers.
Note
Cisco ASR 9001 and Cisco ASR 9001-S Routers Hardware Installation Guide
124
Technical Specifications
Power Consumption Specifications

Cisco ASR 9001 Specifications

General

Router Series	ASR 9000 Series
Rack Units	2 RU
Operating System	Cisco IOS XR
Form Factor	Rack-mountable
Power Supply	AC or DC
Memory	8 GB
Forwarding Capacity	Up to 80 Gbps
Switching Capacity	160 Gbps
Operating Temperature	0 to 40°C
Weight	24 lb
Redundancy	Power supply