CHAPTER 3
Installing Modules and Cables in the Chassis
This chapter contains the procedures for installing cards and modules into the chassis, after it has been
installed in a rack. It also describes how to connect cables to the ports and RP.
•
Fixed 4x10-Gigabit Ethernet Ports, page 57
•
Modular Port Adapters, page 58
•
Installing and Removing Modular Port Adapters, page 67
•
Installing and Removing SFP and XFP Modules, page 73
•
Cable Management, page 73
•
Connecting Route Processor Cables, page 77
•
Connecting Power to the Router, page 80
•
Powering on the Router, page 83
Fixed 4x10-Gigabit Ethernet Ports
The Cisco ASR 9001 Router has four integrated 10 GE small form-factor pluggable (SFP+) ports that operate
at a rate of 10 Gbps.
Each fixed SFP+ port has an adjacent Link LED visible on the front panel. The Link LED indicates the status
of the associated SFP+ port.
In Cisco ASR 9001-S Router, two 10 GE fixed SFP+ ports (SFP+2 and SFP+3) are disabled by default,
and can be enabled by a license upgrade.
Note
Cisco ASR 9001 and Cisco ASR 9001-S Routers Hardware Installation Guide
57
To Next Page
Loading...
