Cisco ASR 9001 Hardware Installation Guide

External USB port6Service LAN and ToD
ports
1
Fixed SFP+ ports9CONSOLE and AUX
ports
4
Management LAN ports5
The following table lists the Cisco ASR 9001 Router front panel ports description.
Table 3: Cisco ASR 9001 Router Front Panel Ports Description
DescriptionConnector TypePort Name
Time of Day Input/Output Port
along with 1PPS Signal. Signal
type is RS422.
RJ45TOD Port
A 10/100Mbps Ethernet Port for
IEEE1588 Grand Master
Connection through CAT5 cable.
Signal type is MLT3.
RJ45Service LAN Port (IEEE 1588)
10MHz Input or Output for GPS
Synchronization. This signal can
provide 10MHz output as well
from Cisco ASR 9001 Router.
Signal type is sinusoidal.
SMB10MHz Connector
1PPS Input or Output for GPS
Synchronization. This signal can
provide output as well from Cisco
ASR 9001 Router. Signal type is
square wave.
SMB1PPS Connector
Used as BITS or DTI (one at a
time) Input/Output Port based on
the configuration used. CAT5
Ethernet cable can be used for DTI.
In DTI mode link resembles an
Ethernet (802.3) 10BaseT link.
Signal type depends on the mode
such as B8ZS for T1, HDB3 for
E1, Manchester Coded Data for
DTI, Sinusoidal for 6.3128 Out.
RJ45SYNC Ports (SYNC 0/SYNC 1)
Cisco ASR 9001 and Cisco ASR 9001-S Routers Hardware Installation Guide
24
Preparing for Installation
Cisco ASR 9001 Router Port Connection Guidelines

Cisco ASR 9001 Specifications

General

Router Series	ASR 9000 Series
Rack Units	2 RU
Operating System	Cisco IOS XR
Form Factor	Rack-mountable
Power Supply	AC or DC
Memory	8 GB
Forwarding Capacity	Up to 80 Gbps
Switching Capacity	160 Gbps
Operating Temperature	0 to 40°C
Weight	24 lb
Redundancy	Power supply