Cisco ASR 903 Installation Instructions

Table 1: Cisco ASR 903 Router Installation Checklist
DateVerified ByTask
Date on which chassis received
Chassis and all accessories unpacked
Types and numbers of interfaces verified
Safety recommendations and guidelines
reviewed
Installation checklist copied
Site log established and background
information entered
Site power voltages verified
Site environmental specifications verified
Required passwords, IP addresses, device
names, and so on available
Required tools available
Network connection equipment available
Cable-management brackets installed
(optional, but recommended)
AC power cables connected to AC sources
and router
DC power cables connected to DC sources
and router
Network interface cables and devices
connected
System power turned on
System boot complete (STATUS LED is
on)
Shared port adapters are operational
Correct software configuration displayed
after system banner appears
Cisco ASR 9000 Series Aggregation Services Router Satellite Systems Installation Guide
18
Installing the Cisco ASR 903 Router as a Satellite Shelf
Installation Checklist

Cisco ASR 903 Specifications

General

Form Factor	Modular
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Humidity	5% to 95% non-condensing
Redundancy	Yes, redundant power supplies and route processors
Operating System	Cisco IOS XE
Power Supply	AC or DC
Switching Capacity	240 Gbps
Operating Temperature	-40°C to 65°C (-40°F to 149°F)
MTBF	200, 000 hours
Supported Protocols	IPv4, IPv6, MPLS, L2VPN, L3VPN
Interfaces	Gigabit Ethernet, 10 Gigabit Ethernet, T1/E1