Cisco ASR 903 Installation Instructions

Table 2: Cisco ASR 903 Router Satellite Shelf Shipping Container Contents
DescriptionComponent
Cisco ASR 903 Router satellite shelf chassisChassis
Fan tray
Power supplies
RSP
Interface modules
Chassis rack-mount brackets (19-inch EIA)Accessories kit
Three sets of screws:
•
Front and rear rack-mount bracket screws (two sets)
•
Cable-management bracket screws
Six cable-management brackets (one per bracket)
One earth lug with two 10-32 screws.
1 RJ-45 to RJ-45 crossover cable
1 RJ-45 to DB-9 (female) adapter
One disposable wrist strap (optional)ESD, wrist strap (disposable)
Regulatory Compliance and Safety Information for the Cisco ASR
903 Router
Documentation
Check the container for the following optional equipment:
•
Power cord if an AC power supply was shipped. There are
no cords for the DC power supply units.
•
T1/E1 cable connector (required only for T1/E1 interface
modules)
Optional equipment
Most Cisco documentation is available online. Documentation that is shipped with your Cisco ASR 903
includes the Regulatory Compliance and Safety Information for the Cisco ASR 903 Router document and
Cisco ASR 903 Documentation Roadmap which contains information about the various documents that
are available online and the links to them.
Note
Cisco ASR 9000 Series Aggregation Services Router Satellite Systems Installation Guide
22
Installing the Cisco ASR 903 Router as a Satellite Shelf
Unpacking and Verifying the Shipped Contents

Cisco ASR 903 Specifications

General

Form Factor	Modular
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Humidity	5% to 95% non-condensing
Redundancy	Yes, redundant power supplies and route processors
Operating System	Cisco IOS XE
Power Supply	AC or DC
Switching Capacity	240 Gbps
Operating Temperature	-40°C to 65°C (-40°F to 149°F)
MTBF	200, 000 hours
Supported Protocols	IPv4, IPv6, MPLS, L2VPN, L3VPN
Interfaces	Gigabit Ethernet, 10 Gigabit Ethernet, T1/E1