Cisco ATA 191 Administration Guide

Port List (ATA 192 only)
DescriptionField
The name of the interface: WAN or LAN.Interface
The number of packets transmitted from this port.TX (pkts)
The number of packets received by this port.RX (pkts)
The status of the port, showing whether the port is connected to a device
or disconnected.
Status
Click this button to reset the count of TX and RX packets to zero.Clear TX & RX
Network Status
Use the Status > Network Status page to view information about the WAN interface (INTERNET port).
Table 80: Basic Interface Detail
DescriptionField
The status of the INTERNET (WAN) interface, showing whether the
port is connected or disconnected.
Link Status
The host name of the ATA.Host Name
The domain name of the ATA.Domain
Table 81: IPv4 Interface Detail
DescriptionField
The IPv4 address of the INTERNET (WAN) interface.IP Address
The subnet mask for the INTERNET (WAN) interface.Subnet Mask
The IPv4 address of the default gateway.Gateway
The method for setting the MTU: Auto or ManualMTU Type
The largest protocol data unit (in bytes) permitted for network
transmission
MTU Size
IPv4 addresses for up to three DNS servers that are used for name
resolution.
DNS 1-3 (if applicable)
Cisco ATA 191 and ATA 192 Analog Telephone Adapter Administration Guide for Multiplatform Firmware
109
Status and Statistics
Network Status

Cisco ATA 191 Specifications

General

Fax Support	T.38 Fax Relay
Relative Humidity	10% to 90% (non-condensing)
Ports	2 FXS ports
Voice Protocol	SIP
Protocols	SIP, RTP, RTCP
Power	5V DC
Network Interfaces	10/100BASE-T Ethernet port
Operating Temperature	32°F to 104°F (0°C to 40°C)
Audio Codecs	G.711 (a-law and μ-law), G.729a, G.722, G.726
Voice Codecs	G.711 (a-law and μ-law), G.729a, G.722, G.726
Storage Temperature	14 to 140°F (-10 to 60°C)