DescriptionField
The loopback mode to assume locally when making call to request
media loopback. Choices are: Source and Mirror.
Default setting: source
If the ATA answers the call, the mode is determined by the
caller.
Note
Media Loopback Mode
The loopback type to use when making call to request media loopback
operation. Choices are Media and Packet.
Default setting: media
Note that if the ATA answers the call, then the loopback type is
determined by the caller (the ATA always picks the first loopback type
in the offer if it contains multiple type)
Media Loopback Type
Enables or disables the CONFCID.
Default setting: yes
CONFCID Setting
Distinctive Ring Settings
Table 63: Distinctive Ring Parameters
DescriptionField
Caller number pattern to play Distinctive Ring/CWT 1, 2, 3, 4, 5, 6, 7,
or 8. Caller number patterns are matched from Ring 1 to Ring 8. The
first match (not the closest match) will be used for alerting the
subscriber. The distinctive rings are set on the Regional page. See
Regional, on page 54.
Default setting: blank
Ring1 - 8 Caller
Ring Settings
Table 64: Ring Parameters
DescriptionField
Default ringing pattern, 1–8, for all callers.
Default setting: 1
Default Ring
Default CWT pattern, 1–8, for all callers.
Default setting: 1
Default CWT
Cisco ATA 191 and ATA 192 Analog Telephone Adapter Administration Guide for Multiplatform Firmware
92
Voice Settings Configuration
Distinctive Ring Settings