DescriptionField
Setting Block Anonymous Calls on or off.
Default setting: no
Block ANC
Setting DND on or off.
Default setting: no
DND
Caller ID Generation on or off.
Default setting: yes
CID Setting
Call Waiting Caller ID Generation on or off.
Default setting: yes
CWCID Setting
Setting Distinctive Ring on or off.
Default setting: yes
Dist Ring
If yes, all outbound calls are secure calls by default, without requiring
the user to dial a star code first.
Default setting: no
•
If Secure Call Setting is set to yes, all outbound calls are secure.
However, a user can disable security for a call by dialing *19
before dialing the target number.
•
If Secure Call Setting is set to No, the user can make a secure
outbound call by dialing *18 before dialing the target number.
•
A user cannot force inbound calls to be secure or not secure; that
depends on whether the caller has security enabled or not.
This setting is applicable only if Secure Call Serv is set to yes
on the line interface. See Line 1 and Line 2 Settings (PHONE
1 and PHONE 2), on page 35.
Note
Secure Call Setting
Setting this value to yes can activate stutter tone and VMWI signal.
This parameter is stored in long term memory and will survive after
reboot or power cycle.
Default setting: no
Message Waiting
Controls how to handle incoming requests for loopback operation.
• never—Never accepts loopback calls; replies 486 to the caller.
• automatic—Automatically accepts the call without ringing.
• manual—Rings the phone first, and the call must be picked up
manually before loopback starts.
Default setting: Automatic
Accept Media Loopback Request
Cisco ATA 191 and ATA 192 Analog Telephone Adapter Administration Guide for Multiplatform Firmware
91
Voice Settings Configuration
Supplementary Service Settings
To Next Page
Loading...
Need help?
General
