EasyManuals Logo

Cisco ATA 191 Administration Guide

Cisco ATA 191
142 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #28 background imageLoading...
Page #28 background image
Table 8: Optional Settings
DescriptionField
Choose the preferred method for choosing a DNS
server.
DHCP-ManualThe DNS server settings from
the network server takes precedence, and your
entries in the DNS fields are used only as a
backup.
Manual-DHCPYour entries in the DNS fields
take precedence, and the DNS server settings
from the network server are used as a backup.
ManualYour entries in the DNS fields are
used to choose a DNS server.
DNS Server Order
Enable if you want to allow Auto Configuration.Allow Auto Configuration.
Set the Primary DNS for IPv6.Primary DNS
Set the Secondary DNS for IPv6.Secondary DNS
IPv4 LAN Settings (ATA 192 Only)
Use the Network Setup > Basic Setup > IPv4 LAN Settings page to set the IP address and subnet mask for
your local network. Also configure the settings for the built-in DHCP server (ATA 192 only).
After making changes, click Submit to save your settings, or click Cancel to redisplay the page with the
saved settings.
Router IP
Enter the Local IP Address and Subnet Mask for your local network. The default setting is 192.168.15.1
with a subnet mask of 255.255.255.0.
DHCP Server Setting
DescriptionField
The ATA can use the built-in DHCP server to
dynamically assign IP addresses to connected devices.
Click Enabled to enable the DHCP server, or
clickDisabled to disable this feature.
Default setting: Enable
DHCP Server
Cisco ATA 191 and ATA 192 Analog Telephone Adapter Administration Guide for Multiplatform Firmware
20
Network Configuration
IPv4 LAN Settings (ATA 192 Only)

Table of Contents

Other manuals for Cisco ATA 191

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ATA 191 and is the answer not in the manual?

Cisco ATA 191 Specifications

General IconGeneral
Fax SupportT.38 Fax Relay
Relative Humidity10% to 90% (non-condensing)
Ports2 FXS ports
Voice ProtocolSIP
ProtocolsSIP, RTP, RTCP
Power5V DC
Network Interfaces10/100BASE-T Ethernet port
Operating Temperature32°F to 104°F (0°C to 40°C)
Audio CodecsG.711 (a-law and μ-law), G.729a, G.722, G.726
Voice CodecsG.711 (a-law and μ-law), G.729a, G.722, G.726
Storage Temperature14 to 140°F (-10 to 60°C)

Related product manuals