Name: Cisco ATA 191
Brand: Cisco
Rating: 5 (1 reviews)

To Next Page

To Previous Page

DescriptionField

The ATA supports bell 202 and v.23 standards for

caller ID generation. Default setting: bell 202

Caller ID FSK Standard:

Select the method you want to use, Default, or

Sweden default. Default setting: Default.

Feature Invocation Method:

Line 1 and Line 2 Settings (PHONE 1 and PHONE 2)

Use the Voice > Line 1 and Voice > Line 2 pages to configure the settings for calls through the PHONE 1

and PHONE 2 ports.

Enter the settings as described. After making changes, click Submit to save your settings, or click Cancel to

redisplay the page with the saved settings.

In a configuration profile, the FXS parameters must include an appropriate numeral for identifying the

port receiving the setting.

Note

General

Table 47: General Settings

DescriptionField

To enable this line for service, select yes. Otherwise, select no.

Default setting: yes

Line Enable

Streaming Audio Server (SAS)

Table 48: Streaming Audio Server Settings

DescriptionField

To enable the use of the line as a streaming audio source, select yes.

Otherwise, select no. If enabled, the line cannot be used for outgoing

calls. Instead, it auto-answers incoming calls and streams audio RTP

packets to the caller.

Default setting: no

SAS Enable

Cisco ATA 191 and ATA 192 Analog Telephone Adapter Administration Guide for Multiplatform Firmware

Voice Settings Configuration

Line 1 and Line 2 Settings (PHONE 1 and PHONE 2)

Other manuals for Cisco ATA 191

Questions and Answers:

Need help?

Do you have a question about the Cisco ATA 191 and is the answer not in the manual?

General