Cisco ATA 191 Administration Guide

DescriptionField
Played when a 486 RSC is received for an outbound call.
Default setting: 480@-19,620@-19;10(.5/.5/1+2)
Busy Tone
Played when an outbound call has failed, or after the far end hangs up
during an established call. Reorder Tone is played automatically when
Dial Tone or any of its alternatives times out.
Default setting: 480@-19,620@-19;10(.25/.25/1+2)
Reorder Tone
Played when the caller has not properly placed the handset on the cradle.
Off Hook Warning Tone is played when the Reorder Tone times out.
Default setting: 480@-10,620@0;10(.125/.125/1+2)
Off Hook Warning Tone
Played during an outbound call when the far end is ringing.
Default setting: 440@-19,480@-19;*(2/4/1+2)
Ring Back Tone
Your ATA plays this tone instead of Ring Back Tone if the called party
replies with a SIP 182 response without SDP to its outbound INVITE
request.
Default setting: the same as Ring Back Tone, except the cadence is 1s
on and 1s off.
Default setting: 440@-19,480@-19;*(1/1/1+2)
Ring Back 2 Tone
Brief tone to notify you that the last input value has been accepted.
Default setting: 600@-16;1(.25/.25/1)
Confirm Tone
Alternative to the Reorder Tone played when an error occurs as a caller
makes an outbound call. The RSC to trigger this tone is configurable
on the SIP screen.
Default setting:
985@-16,1428@-16,1777@-16;20(.380/0/1,.380/0/2,.380/0/3,0/4/0)
SIT1 Tone
Alternative to the Reorder Tone played when an error occurs as a caller
makes an outbound call. The RSC to trigger this tone is configurable
on the SIP screen.
Default setting:
914@-16,1371@-16,1777@-16;20(.274/0/1,.274/0/2,.380/0/3,0/4/0)
SIT2 Tone
Alternative to the Reorder Tone played when an error occurs as a caller
makes an outbound call. The RSC to trigger this tone is configurable
on the SIP screen.
Default setting:
914@-16,1371@-16,1777@-16;20(.380/0/1,.380/0/2,.380/0/3,0/4/0)
SIT3 Tone
Cisco ATA 191 and ATA 192 Analog Telephone Adapter Administration Guide for Multiplatform Firmware
57
Voice Settings Configuration
Call Progress Tones

Cisco ATA 191 Specifications

General

Fax Support	T.38 Fax Relay
Relative Humidity	10% to 90% (non-condensing)
Ports	2 FXS ports
Voice Protocol	SIP
Protocols	SIP, RTP, RTCP
Power	5V DC
Network Interfaces	10/100BASE-T Ethernet port
Operating Temperature	32°F to 104°F (0°C to 40°C)
Audio Codecs	G.711 (a-law and μ-law), G.729a, G.722, G.726
Voice Codecs	G.711 (a-law and μ-law), G.729a, G.722, G.726
Storage Temperature	14 to 140°F (-10 to 60°C)