DescriptionField
If this code is specified, you must enter it before dialing the third party
for a conference call. Enter the code for a conference call.
Default setting: blank
Conference Act Code.
If the code is specified, you must enter it before dialing the third party
for a call transfer. Enter the code for a call transfer.
Default setting: blank
Attn-Xfer Act Code.
Toggles the line to a modem. Modem passthrough mode can be triggered
only by pre-dialing this code.
Default setting: *99
Modem Line Toggle Code.
Toggles the line to a fax machine.
Default setting: #99
FAX Line Toggle Code.
Use for media loopback.
Default setting: *03
Media Loopback Code.
These codes tell the ATA what to do when you place the active call on
hold and is listening to the second dial tone. One or more *codes can
be configured into this parameter, such as *98, or *97|*98|*123, and so
on. The maximum length is 79 characters. This parameter applies when
you place the active call on hold by pressing the hook flash button. Each
*code (and the following valid target number according to current dial
plan) triggers the ATA to perform a blind transfer to a target number
that is prepended by the service *code.
For example, after you dial *98, the ATA plays the Prompt Tone while
waiting for you to enter a target number (which is checked according
to dial plan as in normal dialing). When a complete number is entered,
the ATA sends a blind REFER to the holding party with the Refer-To
target equal to *98 target_number. This feature allows the ATA to hand
off a call to an application server to perform further processing, such
as call park.
The *codes should not conflict with any of the other vertical service
codes internally processed by the ATA. You can empty the
corresponding *code that you do not want the ATA to process.
Default setting: blank
Referral Services Codes.
Cisco ATA 191 and ATA 192 Analog Telephone Adapter Administration Guide for Multiplatform Firmware
67
Voice Settings Configuration
Vertical Service Activation Codes
To Next Page
Loading...
Need help?
General
