Cisco ATA 191 Administration Guide

DescriptionField
Enable Call Forward No Answer Service
Default setting: yes
Cfwd No Ans Serv
Enable Call Forward Selective Service. Configure this service in the
Selective Call Forward Settings section.
Default setting: yes
Cfwd Sel Serv
Enable Forward Last Call Service
Default setting: yes
Cfwd Last Serv
Enable Block Last Call Service
Default setting: yes
Block Last Serv
Enable Accept Last Call Service
Default setting: yes
Accept Last Serv
Enable Do Not Disturb Service
Default setting: yes
DND Serv
Enable Caller ID Service
Default setting: yes
CID–Serv
Enable Call Waiting Caller ID Service
Default setting: yes
CWCID Serv
Enable Call Return Service
Default setting: yes
Call Return Serv
Enable Call Redial Service.
Default setting: yes
Call Redial Serv
Enable Call Back Service.
Default setting: yes
Call Back Serv
Enable Three Way Calling Service. Three Way Calling is required for
Three Way Conference and Attended Transfer.
Default setting: yes
Three Way Call Serv
Enable Three Way Conference Service. Three Way Conference is
required for Attended Transfer.
Default setting: yes
Three Way Conf Serv
Cisco ATA 191 and ATA 192 Analog Telephone Adapter Administration Guide for Multiplatform Firmware
82
Voice Settings Configuration
Supplementary Service Subscription

Cisco ATA 191 Specifications

General

Fax Support	T.38 Fax Relay
Relative Humidity	10% to 90% (non-condensing)
Ports	2 FXS ports
Voice Protocol	SIP
Protocols	SIP, RTP, RTCP
Power	5V DC
Network Interfaces	10/100BASE-T Ethernet port
Operating Temperature	32°F to 104°F (0°C to 40°C)
Audio Codecs	G.711 (a-law and μ-law), G.729a, G.722, G.726
Voice Codecs	G.711 (a-law and μ-law), G.729a, G.722, G.726
Storage Temperature	14 to 140°F (-10 to 60°C)