Cisco C20

To Next Page

To Previous Page

D14582.15R1 (Rev.1 Nov 2013) User guide Prole Series, Codec C Series, Quick Set C20, SX20 Quick Set,

Cisco TelePresence System Prole Series, Codec C Series, Quick Set C20, SX20 Quick Set, MX200, MX300 User guide

www.cisco.com

Settings > Administrator Settings > Call Details

Call Details

If you enable Auto Answer the system will respond by

itself to incoming calls after a delay specied by you.

Note that an activated auto answer may not provide

you with the privacy desired. In the example shown

here Auto Answer is set to O.

On certain occasions you may have to change the

bandwidth (and hence the quality) of the call. Some

congurations may have dierent incoming and

outgoing bandwidths (typically ADSL connections),

and you may specify the default call rate to ensure a

stable video quality.

The default protocol may also be specied. In the

example shown, the protocol has been set to SIP.

This menu is inside the Administrator Settings.

Tap Back to leave the Administrator Settings

and tap Exit to leave all settings.

Other manuals for Cisco C20