52
D14582.15R1 (Rev.1 Nov 2013) User guide Prole Series, Codec C Series, Quick Set C20, SX20 Quick Set,
MX200, MX300. All contents are copyright © 2010–2013 Cisco Systems, Inc. Version TC6.2, 06.2013. English
Cisco TelePresence System Prole Series, Codec C Series, Quick Set C20, SX20 Quick Set, MX200, MX300 User guide
www.cisco.com
Settings > Administrator Settings > Web Snapshots
Web Snapshots
You may gain access to your video system through
its web interface. To learn more about how to do that
consult the Administration Guide for your system. This
guide is available separately for download from www.
cisco.com.
From the web interface you may generate snapshots
of the video stream from your system. You may also,
under certain circumstances, generate snapshots
from the outgoing video of the far end system.
However, you cannot take snapshots unless you have
set the Allow Web Snapshots to ON, as shown here.
Note that the far end may take snapshots of the
outgoing video of your system, even if you have set
your system’s Allow Web Snapshots to OFF.
Likewise, you will be able to take snapshots of the
outgoing video of the far end, even if the far end has
set Allow Web Snapshots to OFF, provided that you
have set your own system’s Allow Web Snapshots to
ON.
Snapshots cannot be taken if the call is encrypted.
Encryption will disable the snapshot feature at both
ends, regardless of the local settings of the Allow
Web Snapshots parameter.
The web snapshot feature applies to Point-to-Point as
well as MultiSite calls (but to unencrypted calls only).
Note that a MultiWay call should be regarded as a
variant of Point-to-Point call as it is the MCU who is
controlling the call and your system is connected to
the MCU as in a Point-to-Point call.
This menu is inside the Administrator Settings.
Tap Back to leave the Administrator Settings
and tap Exit to leave all settings.
To Next Page
Loading...
Need help?
General
