Cisco C20 - EMC Resilience Mode

51
D14582.15R1 (Rev.1 Nov 2013) User guide Prole Series, Codec C Series, Quick Set C20, SX20 Quick Set,
MX200, MX300. All contents are copyright © 2010–2013 Cisco Systems, Inc. Version TC6.2, 06.2013. English
Cisco TelePresence System Prole Series, Codec C Series, Quick Set C20, SX20 Quick Set, MX200, MX300 User guide
www.cisco.com
Settings > Administrator Settings > EMC Resilience Mode
EMC Resilience Mode
If the Touch controller is used in environments with
considerable amounts of electromagnetic noise
present, you may experience an appearance of false
signals—as if someone tapped the Touch controller
when obviously nobody did so.
To cope with this you may set the EMC Resilience
Mode to On. You must then press and hold for a
little while, rather than just tap, in order to make the
system aware of your tapping. This will prevent the
appearance of false signals.
This menu is inside the Administrator Settings.
Tap Back to leave the Administrator Settings
and tap Exit to leave all settings.