Cisco Catalyst 2900 Series XL Hardware Installation Guide

1-21
Catalyst 2900 Series XL Hardware Installation Guide
78-6461-03
Chapter 1 Product Overview
Rear-Panel Description
Note The RPS can only power one switch at a time. If more than one switch fails at
the same time, any subsequent switch is not supported by the RPS until the
first switch failure is resolved.
For more information on the Cisco RPS 300, refer to the Cisco Redundant Power
System 300 Hardware Installation Guide.
Console Port
YoucanconnectaswitchtoaPCthroughtheswitchconsoleportandbyusing
the supplied rollover cable and DB-9 adapter. You need to provide a
RJ-45-to-DB-25 female DTE adapter to connect the switch console port to a
terminal. You can order a kit (part number ACS-DSBUASYN=) containing that
adapter from Cisco. For console port and adapter pinout information, see the
“Connecting to the Console Port” section on page 2-33.

Cisco Catalyst 2900 Series XL Specifications

General

Brand	Cisco
Model	Catalyst 2900 Series XL
Category	Switch
Language	English