2-3
Catalyst 2900 Series XL Hardware Installation Guide
78-6461-03
Chapter 2 Installation
Preparing for Installation
Warning
This product relies on the building’s installation for short-circuit
(overcurrent) protection. Ensure that a fuse or circuit breaker no larger than
120 VAC, 15A U.S. (240 VAC, 10A international) is used on the phase
conductors (all current-carrying conductors).
Warning
This equipment is intended to be grounded. Ensure that the host is
connected to earth ground during normal use.
Warning
Care must be given to connecting units to the supply circuit so that wiring is
not overloaded.
Warning
A voltage mismatch can cause equipment damage and may pose a fire
hazard. If the voltage indicated on the label is different from the power
outlet voltage, do not connect the chassis to that receptacle.
Warning
Do not touch the power supply when the power cord is connected. For
systems with a power switch, line voltages are present within the power
supply even when the power switch is off and the power cord is connected.
For systems without a power switch, line voltages are present within the
power supply when the power cord is connected.
Warning
Do not work on the system or connect or disconnect cables during periods
of lightning activity.
Warning
Ultimate disposal of this product should be handled according to all national
laws and regulations.
To Next Page
Loading...
Need help?
General