Cisco Catalyst 2960-X - Budgeting Power for Devices Connected to a Poe Port; Budgeting Power to a Specific Poe Port

PurposeCommand or Action
(Optional) Disables CDP.no cdp run
Example:
Switch(config)# no cdp run
Step 2
Configures the power consumption of powered devices
connected to each the PoE port on the switch.
power inline consumption default wattage
Example:
Switch(config)# power inline consumption
default 5000
Step 3
The range for each device is 4000 to 30000 mW (PoE+). The
default is 30000 mW.
When you use this command, we recommend you
also enable power policing.
Note
Returns to privileged EXEC mode.end
Example:
Switch(config)# end
Step 4
Displays the power consumption status.show power inline consumption default
Example:
Switch# show power inline consumption default
Step 5
Budgeting Power to a Specific PoE Port
Perform this task to configure the amount of power budgeted to a powered device connected to a specific PoE
port:
SUMMARY STEPS
1.
configure terminal
2.
no cdp run
3.
interface interface-id
4.
power inline consumption wattage
5.
end
6.
show power inline consumption
Catalyst 2960-XR Switch Interface and Hardware Component Configuration Guide, Cisco IOS Release 15.0(2)EX1
OL-29420-01 91
Configuring PoE
Budgeting Power for Devices Connected to a PoE Port