Cisco Catalyst 2960-X - Enabling Wired Location Service on the Switch

PurposeCommand or Action
Example:
Switch# show location admin-tag
or
Switch# show location civic-location
identifier
or
Switch# show location elin-location
identifier
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Switch# copy running-config
Step 8
startup-config
Enabling Wired Location Service on the Switch
Beginning in privileged EXEC mode, follow these steps to enable wired location service on the switch.
SUMMARY STEPS
1.
configure terminal
2.
nmsp notification interval {attachment | location} interval-seconds
3.
end
4.
show network-policy profile
5.
copy running-config startup-config
DETAILED STEPS
PurposeCommand or Action
Enters global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 1
Catalyst 2960-XR Switch Interface and Hardware Component Configuration Guide, Cisco IOS Release 15.0(2)EX1
68 OL-29420-01
Configuring LLDP, LLDP-MED, and Wired Location Service
Configuring Location TLV and Wired Location Service