Cisco Catalyst 2960-X - Example for Configuring Auto-MDIX; Feature History and Information for Auto-MDIX

Verifies the operational state of the auto-MDIX
feature on the interface.
show controllers ethernet-controllerinterface-id
phy
Example for Configuring Auto-MDIX
This example shows how to enable auto-MDIX on a port:
Switch# configure terminal
Switch(config)# interface gigabitethernet1/0/1
Switch(config-if)# speed auto
Switch(config-if)# duplex auto
Switch(config-if)# mdix auto
Switch(config-if)# end
Feature History and Information for Auto-MDIX
ModificationRelease
This feature was introduced.Cisco IOS 15.0(2)EX1
Catalyst 2960-XR Switch Interface and Hardware Component Configuration Guide, Cisco IOS Release 15.0(2)EX1
46 OL-29420-01
Configuring Auto-MDIX
Example for Configuring Auto-MDIX