Provides the location information of a caller. The location is determined by the Emergency location
identifier number (ELIN), which is a phone number that routes an emergency call to the local
public safety answering point (PSAP) and which the PSAP can use to call back the emergency
caller.
◦
Geographic location information
Provides the geographical details of a switch location such as latitude, longitude, and altitude of a
switch.
◦
custom location
Provides customized name and value of a switch location.
Wired Location Service
The switch uses the location service feature to send location and attachment tracking information for its
connected devices to a Cisco Mobility Services Engine (MSE). The tracked device can be a wireless endpoint,
a wired endpoint, or a wired switch or controller. The switch notifies the MSE of device link up and link down
events through the Network Mobility Services Protocol (NMSP) location and attachment notifications.
The MSE starts the NMSP connection to the switch, which opens a server port. When the MSE connects to
the switch there are a set of message exchanges to establish version compatibility and service exchange
information followed by location information synchronization. After connection, the switch periodically sends
location and attachment notifications to the MSE. Any link up or link down events detected during an interval
are aggregated and sent at the end of the interval.
When the switch determines the presence or absence of a device on a link-up or link-down event, it obtains
the client-specific information such as the MAC address, IP address, and username. If the client is LLDP-MED-
or CDP-capable, the switch obtains the serial number and UDI through the LLDP-MED location TLV or
CDP.
Depending on the device capabilities, the switch obtains this client information at link up:
•
Slot and port specified in port connection
•
MAC address specified in the client MAC address
•
IP address specified in port connection
•
802.1X username if applicable
•
Device category is specified as a wired station
•
State is specified as new
•
Serial number, UDI
•
Model number
•
Time in seconds since the switch detected the association
Depending on the device capabilities, the switch obtains this client information at link down:
•
Slot and port that was disconnected
•
MAC address
Catalyst 2960-XR Switch Interface and Hardware Component Configuration Guide, Cisco IOS Release 15.0(2)EX1
56 OL-29420-01
Configuring LLDP, LLDP-MED, and Wired Location Service
Wired Location Service
To Next Page
Loading...
Need help?
General
Weight and Dimensions
