Cisco Catalyst 3550 Series - Configuring Ethernet Interfaces; CHAPTER 11 Configuring SmartPort Macros; Configuring Spanning-Tree Features; Configuring MSTP Features

Contents
xi
Catalyst 3550 Multilayer Switch Software Configuration Guide
78-11194-09
Setting the Interface Speed and Duplex Parameters 10-14
Configuring Inline Power on the Catalyst 3550-24PWR Ports 10-14
Configuring IEEE 802.3X Flow Control 10-15
Adding a Description for an Interface 10-17
Configuring Layer 3 Interfaces 10-18
Monitoring and Maintaining the Interfaces 10-19
Monitoring Interface and Controller Status 10-19
Clearing and Resetting Interfaces and Counters 10-21
Shutting Down and Restarting the Interface 10-22
CHAPTER 11 Configuring SmartPort Macros 11-1
Understanding SmartPort Macros 11-1
Configuring Smart-Port Macros 11-2
Default SmartPort Macro Configuration 11-2
SmartPort Macro Configuration Guidelines 11-2
Creating and Applying SmartPort Macros 11-3
Displaying SmartPort Macros 11-4
CHAPTER 12 Configuring VLANs 12-1
Understanding VLANs 12-1
Supported VLANs 12-2
VLAN Port Membership Modes 12-3
Configuring Normal-Range VLANs 12-4
Token Ring VLANs 12-5
Normal-Range VLAN Configuration Guidelines 12-5
VLAN Configuration Mode Options 12-6
VLAN Configuration in config-vlan Mode 12-6
VLAN Configuration in VLAN Configuration Mode 12-6
Saving VLAN Configuration 12-7
Default Ethernet VLAN Configuration 12-7
Creating or Modifying an Ethernet VLAN 12-8
Deleting a VLAN 12-10
Assigning Static-Access Ports to a VLAN 12-11
Configuring Extended-Range VLANs 12-12
Default VLAN Configuration 12-12
Extended-Range VLAN Configuration Guidelines 12-12
Creating an Extended-Range VLAN 12-13
Creating an Extended-Range VLAN with an Internal VLAN ID 12-14