EasyManuals Logo

Cisco Catalyst 3550 Series User Manual

Cisco Catalyst 3550 Series
992 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #698 background imageLoading...
Page #698 background image
31-20
Catalyst 3550 Multilayer Switch Software Configuration Guide
78-11194-09
Chapter 31 Configuring IP Unicast Routing
Configuring RIP
Configuring Basic RIP Parameters
To configure RIP, you enable RIP routing for a network and optionally configure other parameters.
Beginning in privileged EXEC mode, follow these steps to enable and configure RIP:
IP split horizon Varies with media.
Neighbor None defined.
Network None specified.
Offset list Disabled.
Output delay 0 milliseconds.
Timers basic
Update: 30 seconds.
Invalid: 180 seconds.
Hold-down: 180 seconds.
Flush: 240 seconds.
Validate-update-source Enabled.
Version Receives RIP version 1 and 2 packets; sends version 1 packets.
Table 31-5 Default RIP Configuration (continued)
Feature Default Setting
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
ip routing Enable IP routing (required only if IP routing is disabled).
Step 3
router rip Enable a RIP routing process, and enter router configuration mode.
Step 4
network network number Associate a network with a RIP routing process. You can specify multiple
network commands. RIP routing updates are sent and received through
interfaces only on these networks.
Step 5
neighbor ip-address (Optional) Define a neighboring router with which to exchange routing
information. This step allows routing updates from RIP (normally a
broadcast protocol) to reach nonbroadcast networks.
Step 6
offset list [access-list number | name]
{in | out} offset [type number]
(Optional) Apply an offset list to routing metrics to increase incoming and
outgoing metrics to routes learned through RIP. You can limit the offset list
with an access list or an interface.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 3550 Series and is the answer not in the manual?

Cisco Catalyst 3550 Series Specifications

General IconGeneral
Form FactorRack-mountable
ManageableYes
RAM64 MB
Device TypeSwitch
MAC Address Table Size12000 entries
Routing ProtocolRIP
FeaturesVLAN support
Power SupplyAC 120/230 V (50/60 Hz)
Ports24 or 48 x 10/100Base-TX, 1 x GBIC, 2 x 10/100/1000Base-T
Operating Temperature32 to 113°F (0 to 45°C)

Related product manuals