EasyManuals Logo

Cisco Catalyst 3550 Series User Manual

Cisco Catalyst 3550 Series
992 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #515 background imageLoading...
Page #515 background image
26-7
Catalyst 3550 Multilayer Switch Software Configuration Guide
78-11194-09
Chapter 26 Configuring System Message Logging
Configuring System Message Logging
To disable synchronization of unsolicited messages and debug output, use the no logging synchronous
[level severity-level | all] [limit number-of-buffers] line configuration command.
Enabling and Disabling Time Stamps on Log Messages
By default, log messages are not timestamped.
Beginning in privileged EXEC mode, follow these steps to enable time-stamping of log messages:
To disable time stamps for both debug and log messages, use the no service timestamps global
configuration command.
This example shows part of a logging display with the service timestamps log datetime global
configuration command enabled:
*Mar 1 18:46:11: %SYS-5-CONFIG_I: Configured from console by vty2 (10.34.195.36)
This example shows part of a logging display with the service timestamps log uptime global
configuration command enabled:
00:00:46: %LINK-3-UPDOWN: Interface Port-channel1, changed state to up
Step 5
show running-config Verify your entries.
Step 6
copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
service timestamps log uptime
or
service timestamps log datetime [msec] [localtime]
[show-timezone]
Enable log time stamps.
The first command enables time stamps on log messages,
showing the time since the system was rebooted.
The second command enables time stamps on log messages.
Depending on the options selected, the time stamp can
include the date, time in milliseconds relative to the local
time zone, and the time zone name.
Step 3
end Return to privileged EXEC mode.
Step 4
show running-config Verify your entries.
Step 5
copy running-config startup-config (Optional) Save your entries in the configuration file.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 3550 Series and is the answer not in the manual?

Cisco Catalyst 3550 Series Specifications

General IconGeneral
Form FactorRack-mountable
ManageableYes
RAM64 MB
Device TypeSwitch
MAC Address Table Size12000 entries
Routing ProtocolRIP
FeaturesVLAN support
Power SupplyAC 120/230 V (50/60 Hz)
Ports24 or 48 x 10/100Base-TX, 1 x GBIC, 2 x 10/100/1000Base-T
Operating Temperature32 to 113°F (0 to 45°C)

Related product manuals