EasyManuals Logo

Cisco Catalyst 3550 Series User Manual

Cisco Catalyst 3550 Series
992 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #608 background imageLoading...
Page #608 background image
29-22
Catalyst 3550 Multilayer Switch Software Configuration Guide
78-11194-09
Chapter 29 Configuring QoS
Displaying Auto-QoS Information
Displaying Auto-QoS Information
To display the inital auto-QoS configuration, use the show auto qos [interface [interface-id]] privileged
EXEC command. To display any user changes to that configuration, use the show running-config
privileged EXEC command. You can compare the show auto qos and the show running-config
command output to identify the user-defined QoS settings.
To display information about the QoS configuration that might be affected by auto-QoS, use one of these
commands:
show mls qos
show mls qos map cos-dscp
show mls qos interface [interface-id] [buffers | queueing]
For more information about these commands, refer to the command reference for this release.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 3550 Series and is the answer not in the manual?

Cisco Catalyst 3550 Series Specifications

General IconGeneral
Form FactorRack-mountable
ManageableYes
RAM64 MB
Device TypeSwitch
MAC Address Table Size12000 entries
Routing ProtocolRIP
FeaturesVLAN support
Power SupplyAC 120/230 V (50/60 Hz)
Ports24 or 48 x 10/100Base-TX, 1 x GBIC, 2 x 10/100/1000Base-T
Operating Temperature32 to 113°F (0 to 45°C)

Related product manuals