Cisco Catalyst 3550 Series User Manual

30-18
Catalyst 3550 Multilayer Switch Software Configuration Guide
78-11194-09
Chapter 30 Configuring EtherChannels
Displaying EtherChannel, PAgP, and LACP Status
Displaying EtherChannel, PAgP, and LACP Status
You can use the privileged EXEC commands described in Table 30-3 to display EtherChannel, PAgP,
and LACP status information:
For detailed information about the fields in the command outputs, refer to the command reference for
this release.
Table 30-3 Commands for Displaying EtherChannel, PAgP, and LACP Status
Command Description
show etherchannel [channel-group-number] {detail |
load-balance | port | port-channel | summary}
Displays EtherChannel information in a detailed and one-line
summary form. Also displays the load-balance or
frame-distribution scheme, port, and port-channel information.
show pagp [channel-group-number] {counters |
internal | neighbor}
1
1. You can clear PAgP channel-group information and traffic filters by using the clear pagp {channel-group-number [counters] | counters} privileged
EXEC command.
Displays PAgP information such as traffic information, the
internal PAgP configuration, and neighbor information.
show lacp [channel-group-number] {counters |
internal | neighbor}
2
2. You can clear LACP channel-group information and traffic filters by using the clear lacp {channel-group-number [counters] | counters} privileged
EXEC command.
Displays LACP information such as traffic information, the
internal PAgP configuration, and neighbor information.

Cisco Catalyst 3550 Series Specifications

General

Form Factor	Rack-mountable
Manageable	Yes
RAM	64 MB
Device Type	Switch
MAC Address Table Size	12000 entries
Routing Protocol	RIP
Features	VLAN support
Power Supply	AC 120/230 V (50/60 Hz)
Ports	24 or 48 x 10/100Base-TX, 1 x GBIC, 2 x 10/100/1000Base-T
Operating Temperature	32 to 113°F (0 to 45°C)