EasyManuals Logo

Cisco Catalyst 3550 Series User Manual

Cisco Catalyst 3550 Series
992 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #462 background imageLoading...
Page #462 background image
21-14
Catalyst 3550 Multilayer Switch Software Configuration Guide
78-11194-09
Chapter 21 Configuring Port-Based Traffic Control
Configuring Port Security
Switch(config-if)# switchport port-security mac-address sticky
Switch(config-if)# end
Switch# show port-security address
= Secure Mac Address Table
-------------------------------------------------------------------
Vlan Mac Address Type Ports Remaining Age
(mins)
---- ----------- ---- ----- -------------
1 0000.0000.000a SecureDynamic Fa0/1 -
1 0000.0002.0300 SecureDynamic Fa0/1 -
1 0000.0200.0003 SecureConfigured Fa0/1 -
1 0000.0200.0004 SecureConfigured Fa0/12 -
1 0003.fd62.1d40 SecureConfigured Fa0/5 -
1 0003.fd62.1d45 SecureConfigured Fa0/5 -
1 0003.fd62.21d3 SecureSticky Fa0/5 -
1 0005.7428.1a45 SecureSticky Fa0/8 -
1 0005.7428.1a46 SecureSticky Fa0/8 -
1 0006.1218.2436 SecureSticky Fa0/8 -
-------------------------------------------------------------------
Total Addresses in System :10
Max Addresses limit in System :6176
This example shows how to configure a maximum of eight secure MAC addresses on VLAN 5 on Fast
Ethernet port 12 and verify the configuration:
Switch(config-if)# switchport port-security maximum 8 vlan 5
Switch(config-if)# end
Switch# show port-security interface fastethernet0/12 vlan
Default maximum: not set, using 6176
VLAN Maximum Current
1 default 0
5 8 0
Enabling and Configuring Port Security Aging
You can use port security aging to set the aging time for static and dynamic secure addresses on a port.
Two types of aging are supported per port:
AbsoluteThe secure addresses on the port are deleted after the specified aging time.
InactivityThe secure addresses on the port are deleted only if the secure addresses are inactive for
the specified aging time.
Use this feature to remove and add PCs on a secure port without manually deleting the existing secure
MAC addresses and to still limit the number of secure addresses on a port. You can enable or disable the
aging of statically configured secure addresses on a per-port basis.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 3550 Series and is the answer not in the manual?

Cisco Catalyst 3550 Series Specifications

General IconGeneral
Form FactorRack-mountable
ManageableYes
RAM64 MB
Device TypeSwitch
MAC Address Table Size12000 entries
Routing ProtocolRIP
FeaturesVLAN support
Power SupplyAC 120/230 V (50/60 Hz)
Ports24 or 48 x 10/100Base-TX, 1 x GBIC, 2 x 10/100/1000Base-T
Operating Temperature32 to 113°F (0 to 45°C)

Related product manuals