Contents
xxix
Catalyst 3550 Multilayer Switch Software Configuration Guide
78-11194-09
Configuring Advanced DVMRP Interoperability Features 34-50
Enabling DVMRP Unicast Routing 34-50
Rejecting a DVMRP Nonpruning Neighbor 34-51
Controlling Route Exchanges 34-53
Limiting the Number of DVMRP Routes Advertised 34-53
Changing the DVMRP Route Threshold 34-54
Configuring a DVMRP Summary Address 34-54
Disabling DVMRP Autosummarization 34-56
Adding a Metric Offset to the DVMRP Route 34-56
Monitoring and Maintaining IP Multicast Routing 34-57
Clearing Caches, Tables, and Databases 34-58
Displaying System and Network Statistics 34-58
Monitoring IP Multicast Routing 34-59
CHAPTER
35 Configuring MSDP 35-1
Understanding MSDP 35-1
MSDP Operation 35-2
MSDP Benefits 35-3
Configuring MSDP 35-4
Default MSDP Configuration 35-4
Configuring a Default MSDP Peer 35-4
Caching Source-Active State 35-6
Requesting Source Information from an MSDP Peer 35-8
Controlling Source Information that Your Switch Originates 35-8
Redistributing Sources 35-9
Filtering Source-Active Request Messages 35-11
Controlling Source Information that Your Switch Forwards 35-12
Using a Filter 35-12
Using TTL to Limit the Multicast Data Sent in SA Messages 35-14
Controlling Source Information that Your Switch Receives 35-14
Configuring an MSDP Mesh Group 35-16
Shutting Down an MSDP Peer 35-16
Including a Bordering PIM Dense-Mode Region in MSDP 35-17
Configuring an Originating Address other than the RP Address 35-18
Monitoring and Maintaining MSDP 35-19
CHAPTER
36 Configuring Fallback Bridging 36-1
Understanding Fallback Bridging 36-1
Configuring Fallback Bridging 36-3
To Next Page
Loading...
