Index
IN-11
Catalyst 3550 Multilayer Switch Software Configuration Guide
78-11194-09
enabling unicast routing 34-50
interoperability
with Cisco devices
34-44
with Cisco IOS software 34-11
mrinfo requests, responding to 34-49
neighbors
advertising the default route to
34-48
discovery with Probe messages 34-11, 34-44
displaying information 34-49
prevent peering with nonpruning 34-52
rejecting nonpruning 34-51
overview 34-11
routes
adding a metric offset
34-56
advertising all 34-56
advertising the default route to neighbors 34-48
caching DVMRP routes learned in report
messages
34-50
changing the threshold for syslog messages 34-54
deleting 34-58
displaying 34-58
favoring one over another 34-56
limiting the number injected into MBONE 34-53
limiting unicast route advertisements 34-44
route table, building 34-11
source distribution tree, building 34-11
support for 1-6
tunnels
configuring
34-46
displaying neighbor information 34-49
dynamic access ports
characteristics
12-3
configuring 12-32
defined 10-3
dynamic addresses
See addresses
dynamic desirable trunking mode
12-17
Dynamic Host Configuration Protocol
See DHCP-based autoconfiguration
dynamic port VLAN membership
described
12-28
reconfirming 12-32, 12-33
troubleshooting 12-34
types of connections 12-32
VMPS database configuration file 12-28
dynamic routing 31-2
Dynamic Trunking Protocol
See DTP
E
EBGP 31-44
editing features
enabling and disabling
2-7
keystrokes used 2-7
wrapped lines 2-8
egress q, in show forward command output 37-19
EIGRP
and IGRP
31-40
authentication 31-42
components 31-38
configuring 31-40
default configuration 31-39
definition 31-38
interface parameters, configuring 31-41
monitoring 31-43
support for 1-6
enable password 8-4
enable secret password 8-4
encryption for passwords 8-4
Enhanced IGRP
See EIGRP
environment variables
function of
4-16
location in Flash 4-15
equal-cost routing 1-6, 31-76
To Next Page
Loading...
