4-11
Catalyst 3550 Multilayer Switch Software Configuration Guide
78-11194-09
Chapter 4 Assigning the Switch IP Address and Default Gateway
Checking and Saving the Running Configuration
interface GigabitEthernet0/1
no switchport
ip address 172.20.137.50 255.255.255.0
!
interface GigabitEthernet0/2
!
interface GigabitEthernet0/3
!
interface GigabitEthernet0/4
!
interface GigabitEthernet0/5
!
interface GigabitEthernet0/6
!
interface GigabitEthernet0/7
!
interface GigabitEthernet0/8
!
interface GigabitEthernet0/9
!
interface GigabitEthernet0/10
!
interface GigabitEthernet0/11
!
interface GigabitEthernet0/12
...!
interface VLAN1
ip address 172.20.137.50 255.255.255.0
no ip directed-broadcast
!
ip default-gateway 172.20.137.1 !
!
snmp-server community private RW
snmp-server community public RO
snmp-server community private@es0 RW
snmp-server community public@es0 RO
snmp-server chassis-id 0x12
!
end
To store the configuration or changes that you have made to your startup configuration in Flash memory,
enter this privileged EXEC command:
Switch# copy running-config startup-config
Destination filename [startup-config]?
Building configuration...
This command saves the configuration settings that you made. If you fail to do this, your configuration
will be lost the next time you reload the system. To display information stored in the NVRAM section
of Flash memory, use the show startup-config or more startup-config privileged EXEC command.
For more information about alternative locations to copy the configuration file, see Appendix B,
“Working with the Cisco IOS File System, Configuration Files, and Software Images.”
To Next Page
Loading...
Need help?
General
