Cisco Catalyst 6500 Series - Ssl-Proxy Ip-Frag-Ttl

2-94
Catalyst 6500 Series Switch SSL Services Module Command Reference
OL-9105-01
Chapter 2 Commands for the Catalyst 6500 Series SSL Services Module
ssl-proxy ip-frag-ttl
ssl-proxy ip-frag-ttl
To adjust the IP fragment reassembly timer, use the ssl-proxy ip-frag-ttl command.
ssl-proxy ip-frag-ttl time
Syntax Description
Defaults time is 6 seconds.
Command Modes Global configuration
Command History
Examples This example shows how to configure the IP reassembly timeout to 60 seconds:
ssl-proxy(config)# ssl-proxy ip-frag-ttl 60
ssl-proxy(config)#
time (Optional) Adjust the IP fragment reassembly timer; valid values
are from 3 to 120 seconds.
Release Modification
SSL Services Module
Release 3.1(1)
Support for this command was introduced on the Catalyst 6500 series
SSL Services Module.