Cisco Catalyst 6500 Series Command Reference

2-59
Catalyst 6500 Series Switch SSL Services Module Command Reference
OL-9105-01
Chapter 2 Commands for the Catalyst 6500 Series SSL Services Module
show interfaces ssl-proxy
show interfaces ssl-proxy
To display information about the configured subinterfaces, use the show interfaces ssl-proxy command.
show interfaces ssl-proxy 0.subinterface
Syntax Description
Defaults This command has no default settings.
Command Modes EXEC
Command History
Examples This example shows how to display information about the configured subinterfaces:
ssl-proxy# show ionterfaces 0.3
SSL-Proxy0.3 is up, line protocol is up
Hardware is STE interface, address is 0001.6445.c744 (bia 00e0.14c1.30e9)
Internet address is 10.10.0.16/8
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation 802.1Q Virtual LAN, Vlan ID 3.
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters never
ssl-proxy#
Related Commands policy tcp
subinterface-number Subinterface ID; valid values are from 0 to 4294967295.
Release Modification
SSL Services Module
Release 3.1(1)
Support for this command was introduced on the Catalyst 6500 series
SSL Services Module.

Cisco Catalyst 6500 Series Specifications

General

Brand	Cisco
Model	Catalyst 6500 Series
Category	Switch
Language	English