EasyManuals Logo

Cisco Catalyst 6500 Series Command Reference

Cisco Catalyst 6500 Series
160 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #53 background imageLoading...
Page #53 background image
2-27
Catalyst 6500 Series Switch SSL Services Module Command Reference
OL-9105-01
Chapter 2 Commands for the Catalyst 6500 Series SSL Services Module
interface ssl-proxy
interface ssl-proxy
To enter the subinterface configuration submode, use the interface ssl-proxy command. In interface
configuration submode, you can configure a subinterface for the SSL Services Module.
Note The ssl-proxy0 interface is enabled by default and should not be shut down or otherwise configured.
interface 0.subinterface-number
Syntax Description
Defaults This command has no default settings.
Command Modes Global configuration
Command History
Usage Guidelines When you upgrade to SSL software release 3.x from SSL software release 2.x or 1.x, the VLAN
configuration is converted automatically to an subinterface configuration. For example, ssl-proxy vlan 3
is converted to interface ssl-proxy0.3.
Note The ssl-proxy0 interface is enabled by default and should not be shut down or otherwise configured.
Table 2-1 lists the commands that are available in subinterface configuration submode.
subinterface-number Subinterface ID; valid values are from 0 to 4294967295.
Release Modification
SSL Services Module
Release 3.1(1)
Support for this command was introduced on the Catalyst 6500 series
SSL Services Module.
This command replaces the ssl-proxy vlan command.
Table 2-1 Subinterface Configuration Submode Command Descriptions
Syntax Description
default Sets a command to its defaults.
description Allows you to enter a description for the subinterface.
encapsulation dot1q vlan_ID [native] Sets the encapsulation type for the interface. Enter the native keyword to
make this a native VLAN.
exit Exits from the subinterface configuration submode.
ip address ipaddress subnet [secondary] Configures the subinterface with an IP address and a subnet mask. Enter the
secondary keywork to make this IP address a secondary address.
no Negates a command or sets its defaults.

Table of Contents

Other manuals for Cisco Catalyst 6500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 6500 Series and is the answer not in the manual?

Cisco Catalyst 6500 Series Specifications

General IconGeneral
BrandCisco
ModelCatalyst 6500 Series
CategorySwitch
LanguageEnglish

Related product manuals