To Next Page

To Previous Page

2-116

Catalyst 6500 Series Switch SSL Services Module Command Reference

OL-9105-01

Chapter 2 Commands for the Catalyst 6500 Series SSL Services Module

standby version

To change the version of the Hot Standby Router Protocol (HSRP), use the standby version command:

standby version {1 | 2}

Syntax Description

Defaults The default HSRP version is 1.

Command Modes Subinterface configuration submode

Command History

Usage Guidelines HSRP version 2 addresses limitations of HSRP version 1 by providing an expanded group number range

of 0 to 4095.

HSRP version 2 will not interoperate with HSRP version 1. An interface cannot operate both version 1

and version 2 because both versions are mutually exclusive. You cannot change from version 2 to version

1 if you have configured groups above 255. Using the no standby version command sets the HSRP

version to the default version, version 1.

If an HSRP version is changed, each group will reinitialize because it now has a new virtual MAC

address.

Examples This example shows how to configure HSRP version 2:

ssl-proxy (config-subif)# standby version 2

ssl-proxy (config-subif)#

1 Specifies HSRP version 1.

2 Specifies HSRP version 2.

Release Modification

SSL Services Module

Release 2.1(1)

Support for this command was introduced on the Catalyst 6500 series

switches.

SSL Services Module

Release 3.1(1)

The command mode for this command was changed from Proxy-VLAN to

Subinterface.

Cisco Catalyst 6500 Series Command Reference

Other manuals for Cisco Catalyst 6500 Series