EasyManuals Logo

Cisco Catalyst 6500 Series Command Reference

Cisco Catalyst 6500 Series
160 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #139 background imageLoading...
Page #139 background image
2-113
Catalyst 6500 Series Switch SSL Services Module Command Reference
OL-9105-01
Chapter 2 Commands for the Catalyst 6500 Series SSL Services Module
standby track
standby track
To configure HSRP to track an object and change the hot standby priority based on the state of the object,
use the standby track command. Use the no form of this command to remove the tracking.
standby [group-number] track object-number [decrement priority]
no standby [group-number] track object-number [decrement priority]
Syntax Description
Defaults The defaults are as follows:
group-number is 0.
priority is 10.
Command Modes Subinterface configuration submode
Command History
Usage Guidelines This command ties the hot standby priority of the router to the availability of its tracked objects. Use the
track interface or track ip route global configuration command to track an interface object or an IP
route object. The HSRP client can register its interest in the tracking process by using the standby track
command commands and take action when the object changes.
When a tracked object goes down, the priority decreases by 10. If an object is not tracked, its state
changes do not affect the priority. For each object configured for hot standby, you can configure a
separate list of objects to be tracked.
The optional priority argument specifies how much to decrement the hot standby priority when a tracked
object goes down. When the tracked object comes back up, the priority is incremented by the same
amount.
When multiple tracked objects are down, the decrements are cumulative, whether configured with
priority values or not.
Use the no standby group-number track command to delete all tracking configuration for a group.
group-number (Optional) Group number to which the tracking applies.
object-number Object number in the range from 1 to 500 representing the object to be
tracked.
decrement priority (Optional) Specifies the amount by which the hot standby priority for the
router is decremented (or incremented) when the tracked object goes down
(or comes back up).
Release Modification
SSL Services Module
Release 2.1(1)
Support for this command was introduced on the Catalyst 6500 series
switches.
SSL Services Module
Release 3.1(1)
The command mode for this command was changed from Proxy-VLAN to
Subinterface.

Table of Contents

Other manuals for Cisco Catalyst 6500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 6500 Series and is the answer not in the manual?

Cisco Catalyst 6500 Series Specifications

General IconGeneral
BrandCisco
ModelCatalyst 6500 Series
CategorySwitch
LanguageEnglish

Related product manuals