Cisco Catalyst 6500 Series - Configuring OSPF

2-100
Catalyst 6500 Series Switch SSL Services Module Command Reference
OL-9105-01
Chapter 2 Commands for the Catalyst 6500 Series SSL Services Module
standby ip
Examples This example shows how to activate HSRP for group 1 on Ethernet interface 0. The IP address that is
used by the hot standby group is learned using HSRP.
ssl-proxy (config-subif)# standby 1 ip
ssl-proxy (config-subif)#
This example shows how to indicate that the IP address is a secondary hot standby router interface:
ssl-proxy (config-subif)# standby ip 1.1.1.254
ssl-proxy (config-subif)# standby ip 1.2.2.254 secondary
ssl-proxy (config-subif)# standby ip 1.3.3.254 secondary