1-4
Catalyst 6500 Series Switch SSL Services Module Command Reference
OL-9105-01
Chapter 1 Command-Line Interface
How to Find Command Options
ssl-proxy(config-if)# channel-group group ?
<1-256> Channel group number
ssl-proxy(config-if)#channel-group group
After you enter the group keyword,
enter a ? to display what you must
enter next on the command line. In
this example, you must enter a channel
group number from 1 to 256.
Because a
<cr> is not displayed, it
indicates that you must enter more
information to complete the
command.
ssl-proxy(config-if)# channel-group 1 ?
mode Etherchannel Mode of the interface
ssl-proxy(config-if)#
After you enter the channel group
number, enter a ? to display what you
must enter next on the command line.
In this example, you must enter the
mode keyword.
Because a
<cr> is not displayed, it
indicates that you must enter more
information to complete the
command.
ssl-proxy(config-if)# channel-group 1 mode ?
auto Enable PAgP only if a PAgP device is detected
desirable Enable PAgP unconditionally
on Enable Etherchannel only
ssl-proxy(config-if)#
After you enter the mode keyword,
enter a ? to display what you must
enter next on the command line. In
this example, you must enter the auto,
desirable, or on keyword.
Because a
<cr> is not displayed, it
indicates that you must enter more
information to complete the
command.
ssl-proxy(config-if)# channel-group 1 mode auto ?
<cr>
ssl-proxy(config-if)#
In this example, the auto keyword is
entered. After you enter the auto
keyword, enter a ? to display what you
must enter next on the command line.
Because a
<cr> is displayed, it
indicates that you can press Return to
complete the command. If additional
keywords are listed, you can enter
more keywords or press Return to
complete the command.
ssl-proxy(config-if)# channel-group 1 mode auto
ssl-proxy(config-if)#
In this example, press Return to
complete the command.
Table 1-2 How to Find Command Options (continued)
Command Comment
To Next Page
Loading...
