Cisco Catalyst 6800 User Manual

DescriptionFeature
•
Number of egress queues: 8
•
Number of ingress queues: 8
•
Number of thresholds per egress queue: 4
•
Number of thresholds per ingress queue: 4
QoS
Up to 9216 bytes per frameMaximum frame size
2:1 oversubscription in a Cisco Catalyst 6807-XL chassis. (When
all thirty-two 10G ports are used.)
4:1 oversubscription in a Cisco Catalyst 6500 E-series
chassis.(When all thirty-two 10G ports are used.)
Module oversubscription rate
Supervisor Engine 2T-10GESupervisor engine support
With Supervisor Engine 2T-10GE —Cisco IOS Release 15.2(1)SY
or later
Software support
With a WS-F6K-DFC4-E/ / EXL daughter card:
• Tx—1p7q4t
• Rx—2p6q4t
Queues per port
The following restrictions apply to module installation and
operation:
• Module installation—Modules must be installed in adjacent
slots. To maintain an adequate air flow through the chassis,
install a switching-module filler plate (Cisco part number
WS-X6K-SLOT-CVR-E=) in unused slots, rather than a
blank slot cover (Cisco part number
WS-X6K-SLOT-CVR=).
• Module operation—C6800-32P10G/ 10G-XL operates only
in a Cisco Catalyst 6807-XL and a Cisco Catalyst 6500
E-series chassis equipped with a Supervisor Engine
2T-10GE.
• Slot restrictions—In the following switch chassis, you
cannot install Ethernet modules in slots meant for supervisor
engines:
•
In a Cisco Catalyst 6807-XL, the supervisor engine
slots are 3 and 4.
•
In a Cisco Catalyst 6513 E-series chassis, the
supervisor engine slots are 7 and 8. This restriction
does not apply to any other 6500 E-series chassis.
Chassis and slot restrictions
Catalyst 6800 Ethernet Module Installation Guide
15
Ethernet Switching Modules Overview
C6800-32P10G and C6800-32P10G-XL Ethernet Modules

Cisco Catalyst 6800 Specifications

General

Brand	Cisco
Model	Catalyst 6800
Category	Server
Language	English