10. active
11. exit
12. exit
13. ip http client source-interface interface-type interface-number
14. crypto pki trustpoint name
15. revocation-check none
16. end
17. copy running-config startup-config
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
Enter your password if prompted.
Device> enable
Enters global configuration mode.configure terminal
Example:
Step 2
Device# configure terminal
Enters Call Home configuration mode.call-home
Example:
Step 3
Device(config)# call-home
Disables server identity check when HTTP connection is
established.
no http secure server-identity-check
Example:
Step 4
Device(config-call-home)# no http secure
server-identity-check
Enters Call Home destination profile configuration mode
for the specified destination profile name. If the specified
destination profile does not exist, it is created.
profile name
Example:
Device(config-call-home)# profile test1
Step 5
Enables data sharing with the Call Home service via HTTP.reporting smart-licensing-data
Example:
Step 6
Device(config-call-home-profile)# reporting
smart-licensing-data
Enables the HTTP message transport method.destination transport-method http
Example:
Step 7
Device(config-call-home-profile)# destination
transport-method http
Configures the destination URL (CSSM) to which Call
Home messages are sent.
destination address http url
Example:
Step 8
Note
System Management Configuration Guide, Cisco IOS XE Gibraltar 16.10.x (Catalyst 9200 Switches)
96
Configuring Smart Licensing
Configuring the Call Home Service for Cisco Smart Software Manager On-Prem
To Next Page
Loading...
