Cisco Catalyst 9200 - Page 111

PurposeCommand or Action
Device(config-call-home-profile)#
destination address http
Ensure the IP address or the fully qualified domain name
(FQDN) in the destination URL matches the IP address or
https://209.165.201.15:443/Transportgateway/services/DeviceRequestHandler
the FQDN as configured for the Satellite Name on the
Cisco Smart Software Manager On-Prem.
or
Device(config-call-home-profile)#
destination address http
http://209.165.201.15:80/Transportgateway/services/DeviceRequestHandler
(Optional) Configures a preferred message format. The
default is XML.
destination preferred-msg-format{long-text | short-text
| xml}
Example:
Step 9
Device(config-call-home-profile)# destination
preferred-msg-format xml
Enables the destination profile. By default, a profile is
enabled when it is created.
active
Example:
Step 10
Device(config-call-home-profile)# active
Exits Call Home destination profile configuration mode
and returns to Call Home configuration mode.
exit
Example:
Step 11
Device(config-call-home-profile)# exit
Exits Call Home configuration mode and returns to global
configuration mode.
exit
Example:
Step 12
Device(config-call-home)# exit
Configures a source interface for the HTTP client.ip http client source-interface interface-type
interface-number
Step 13
The ip http client source-interface
interface-type interface-number command is
mandatory for a vrf interface.
Note
Example:
Device(config)# ip http client source-interface
Vlan100
(Optional) Declares the trustpoint and a given name and
enters ca-trustpoint configuration mode.
crypto pki trustpoint name
Example:
Step 14
Device(config)# crypto pki trustpoint
SLA-TrustPoint
(Optional) Specifies that certificate checking is ignored.revocation-check none
Example:
Step 15
Device(ca-trustpoint)# revocation-check none
(Optional) Exits ca-trustpoint configuration mode and
returns to privileged EXEC mode.
end
Example:
Step 16
Device(ca-trustpoint)# end
System Management Configuration Guide, Cisco IOS XE Gibraltar 16.10.x (Catalyst 9200 Switches)
97
Configuring Smart Licensing
Configuring the Call Home Service for Cisco Smart Software Manager On-Prem